makavele:


attendance? i gat the keys to "toyota trans wahala"

Abeg where your workshop dey?

Kashif:


Which seal was replaced?

Thanks for the response, don't know the specific seal but can get the info tomorrow. The location of the seal is on the right side by the shaft.
Thanks

hello house evening! pls car doctor my Honda bulldog raises engine before before selecting gear and I noticed that the transmission oil is licking from the drainage bolt . pls what should I do. because am afraid of driving the car out .
and I also smell burning oil while driving pls any solutions?

Hello Car Doctor,

I drive a 2010 Toyota Camry and it's transmission is not selecting properly; it enters gear 1 but not 2 and 3.... even when it enters gear 2 it quickly disengage and the engine rolls.

A gear mechanic that checked said the gear pump is rusty and he changed it. Still the same problem. In fact I noticed that it was after he changed the gear pump that it refuse to enter reverse gear.

Pls, how can I solve this problem. Do you think changing the gear entirely is the best option? Or it can still be repaired? Changing the gear at this time is very difficult because the mechanic said it cost up to 500k.

Thanks

Pm me..if u are in abuja..had same issues and somone fixed it for me for a reasonable price..havnt had same issue again

Kindly recommend a good gearbox technician around Alimosho axis to me.

Please help...

qajape:
Hello Car Doctor,

I drive a 2010 Toyota Camry and it's transmission is not selecting properly; it enters gear 1 but not 2 and 3.... even when it enters gear 2 it quickly disengage and the engine rolls.

A gear mechanic that checked said the gear pump is rusty and he changed it. Still the same problem. In fact I noticed that it was after he changed the gear pump that it refuse to enter reverse gear.

Pls, how can I solve this problem. Do you think changing the gear entirely is the best option? Or it can still be repaired? Changing the gear at this time is very difficult because the mechanic said it cost up to 500k.

Thanks

The gear expert that told you your transmission pump was rusty is a moronic thief! . That is not possible! He did not change anything!! Why are some people wicked?? No wonder nobody has any confidence in the industry.

Check and confirm other ranges you dont have. Your transmission has a long failsafe strategy, which disables some ranges, depending on the failure detected. Reverse is however not affected. You need to scan for codes, but i am sure ratio codes will be there. In the absense a scanner, disconnect the battery momentarily and reconnect. Use the manual shift to see what you have before it goes to failesafe again.

That transmission is difficult to diagnose in that car, because the clutch pressure ports are too close to the subframe! Not fun!

Try the above and get back.

Aladine:
Pm me..if u are in abuja..had same issues and somone fixed it for me for a reasonable price..havnt had same issue again

Spill it here.

Kashif:


Which seal was replaced?

.
It's the shaft seal. Thank.
@kashif, Is it OK to call you?

Yeahmee:
.
It's the shaft seal. Thank.
@kashif, Is it OK to call you?

I am not able to figure out how a shaft change would cause delayed engagement. The major problem is I cant ID your transmission.

Yes you can call.

Kashif:


I am not able to figure out how a shaft change would cause delayed engagement. The major problem is I cant ID your transmission.

Yes you can call.

Please email your number to yeahmee@gmail.com.

Thanks sir

How much is galaxy 2009 gear box? I need it urgently

Hi Mavrodians, serious pairing going on. Almost every one is being matched to PH or GH, No more small talk, its action time.
For the many people calling me every minute of every day asking if mmm is truly back or not and wondering whats going on, now is the time to show that YOU and I are d MMM, whatever we do from now determines if mmm will be sustained or not.
go PH and GH, then PH again. Mavrodi no go dash u his own money to sustain d community. If u are to PH, do it fast today, dont wait till monday. If u are d GH, after ghing, then PH again!!!. Todays list is too long, i cant write it down, na screenshot i go do. Check to see if u or ur downlines has been matched.

THE KEY IS THIS

DON'T talk bad about mmm in the public because your Gh is someone else's PH .if you talk bad about mmm in the public you wouldn't know if the person that will pay your Gh is there and by talking bad of mmm you have destroyed that other person's good mind in mmm and at last nobody will pay your Gh.so Keep speaking good about mmm in the public and soon you can Gh and be paid. i see mmm nigeria entering into 10million active & serious participants this year 2017

✍✍ *Guider YINKA*

Kashif:


I am not able to figure out how a shaft change would cause delayed engagement. The major problem is I cant ID your transmission.

Yes you can call.

@kashif is a super star ⭐. Spoke to him earlier in week and I really want to be like him when I grow up.
Thanks a lot sir.

Please I need a good mechanic that can fix my 1998 Honda babyboy gearbox as I was told the problem is from the gearbox..... It jerk seriously each time I engage it on either reverse or drive and after sometime it will loose drive in Motion....i can only drive it manually after removing the gearswitch cord..... I just bought the gear 3months ago.....

Good day Car doctor, I have a Honda Pilot 2007, I changed the gearbox oil to Dexon III as stipulated in d veh manual and a week later my gearbox sensor was service using carburetor cleaner becos most time it produce a nerking sound when selecting, five days later d gearbox wasn't selecting beyond 2, now I'm stock with my mech who is saying it's d sensor. what do I do? I'm in abuja, with d expenses I have incurred is so much. how can I get to ur shop. my email dathors@gmail.com and number 07039525097

Pls Car Doctor, what is the recommended gear oil for Nissan Altima 2000 model... I've been using Holts ATF on it, I observed lately that the transmission is making some humming noise and it loses power after driving for long hours. Pls advice... thanks

Marpol:


If it is a Honda Accord, kindly remove it fast!

I just had my gearbox change, i noticed the ATF fluid used by the Mechanic is Seahorse ATF fluid, Dextron III. Please is this Oil appropriate. The car is still working fine. Can I change the oil to ATF-Z1 after a while? the car almost noticeably jack when changing gear especially when changing from 1to 2

The model is Honda Odeyssey 2000 model. Thank you.

Hello gurus.. Have been using Mobil atf for my Honda accord 2000 v4... I observed that sometimes.. My car jerks.. And delays for like 2-3 seconds before shifting gear.. Please.. What's the recommended atf to use for my honda-accord 2000 v4.. Thanks...

Cc.. Kashif, cardoctor, luvinhubby...advice your boi pls

Check your oil dip

Hello @kashif.. Please what am I expected to lookout for in the oil dipstick?? Thanks a lot.

pls assist me.. my corolla 2003 model is jerking, wen I slow down at traffic light it takes time for the car to respond, I serviced the injector and fuel pump but it is still the same,

Tochiokoye:
pls assist me.. my corolla 2003 model is jerking, wen I slow down at traffic light it takes time for the car to respond, I serviced the injector and fuel pump but it is still the same,

My brother 2003 corrolla has same issue,which we are just resolved.Kindly scan the and let me know the code.

check you transmission oil,if still ok.

captainking:
Hello @kashif.. Please what am I expected to lookout for in the oil dipstick?? Thanks a lot.

Look for the fluid to use. It should be written on the dip stick.

Kashif:


Look for the fluid to use. It should be written on the dip stick.

ohhhhkkkkk... I never knew that... Thanks a lot boss... I deeply appreciate

Hi

I have a golf 3 of 1997 model, 2.0L injector with auto transmission. I have had it for abt 3 years now

My mech has changed the transmission oil and steering fluid as well and reading theses threads has me worried. The kick down isn't working already

Which of the fluids available should I use as;
1 - transmission fluid
2 - steering fluid

Is there something I can do to revice the car?

Thanks

Which ATF will you recommend for 1997 Mercedes Benz E230?

dear all. I topped my Honda accord 2010 V6 with gear oil and engine oil with OANDO dexron ii with 1litre. Ever since then, my I noticed sluggish in acceleration, this happens when the engine is hot. Pls gurus in the house kindly help me ooo.

Thanks

Hello Car Dr. & car Gurus in the house. I own a Nissan Altima 2003 S model. Whenever i change gear from P to R or to D or from D to R, the car jerks. Changing from N to D is worst! The jerking is more pronounced when I've driven the car for about 45mins to 1 hr. I'm not short of oil and the engine seats aren't bad.

Please how do i fix this problem?

My mechanic recently suggested that i get the gear serviced by just draining the oil, cleaning all dirts and putting fresh oil. But I'm afraid this could do more harm than good.

Please advise.

We sell diagnosis tools for your cars visit us (www.Masquest.net) we also offer training services.
08034636279,08100981296.

Petmayor:
Hello Car Dr. & car Gurus in the house. I own a Nissan Altima 2003 S model. Whenever i change gear from P to R or to D or from D to R, the car jerks. Changing from N to D is worst! The jerking is more pronounced when I've driven the car for about 45mins to 1 hr. I'm not short of oil and the engine seats aren't bad.

Please how do i fix this problem?

My mechanic recently suggested that i get the gear serviced by just draining the oil, cleaning all dirts and putting fresh oil. But I'm afraid this could do more harm than good.

Please advise.

You are likely having high internal pressure. Your mechanic can turn the pressure solenoid counter clockwise 90 to 180 degrees, to see if it helps.

Petmayor:
Hello Car Dr. & car Gurus in the house. I own a Nissan Altima 2003 S model. Whenever i change gear from P to R or to D or from D to R, the car jerks. Changing from N to D is worst! The jerking is more pronounced when I've driven the car for about 45mins to 1 hr. I'm not short of oil and the engine seats aren't bad.

Please how do i fix this problem?

My mechanic recently suggested that i get the gear serviced by just draining the oil, cleaning all dirts and putting fresh oil. But I'm afraid this could do more harm than good.

Please advise.

How will he go about the bolded?