If you are having trouble networking systems or Thin client terminals, contact me for details

Hey bro thanks for your post, really need someone to will put me through just got an IT support job
am just to make sure the systems are working perfectly and users are able to access the internet.
just want to know how to configure and setup from scratch. we have one wireless router, cisco switch one proxy server and one
other application server then 2 service provider equipment smile and ipnx. thanks expecting your reply soonest.

I believe you have a basic understanding of the regular network and setup interface
Setup
To get things started, make sure you have good network cables - faulty cables can give you a whole lot of headache after your setup is complete. If you this sorted, run a Lan cable from your service ISP’s device into your router‘s up-link port and feed the server from port 2 of your Router.
Next, run a Lan cable from your networked Switch to the Router and from there, to the Application server. Configure the adapter settings on the LAN adapter for your application server and User Terminals to use static IP addresses by assigning an individual IP address to each user PC or terminal. This would allow 2 way distributions from your Server to the User PCs or terminals through the switch.
By now, your server should have identified two LAN Connections – 1, for the router (Internet) and the other for the Switch (Intranet).
You can go to your wireless router’s log in page to configure settings such as wireless passwords, an internet security and firewall settings. If your proxy server is installed, it should run and connect with the settings assigned on installation.
If your user accounts have been set up, they should be able to connect to the network without problems at this point.
I hope this helps.

cooljyd: I believe you have a basic understanding of the regular network and setup interface
Setup
To get things started, make sure you have good network cables - faulty cables can give you a whole lot of headache after your setup is complete. If you this sorted, run a Lan cable from your service ISP’s device into your router‘s up-link port and feed the server from port 2 of your Router.
Next, run a Lan cable from your networked Switch to the Router and from there, to the Application server. Configure the adapter settings on the LAN adapter for your application server and User Terminals to use static IP addresses by assigning an individual IP address to each user PC or terminal. This would allow 2 way distributions from your Server to the User PCs or terminals through the switch.
By now, your server should have identified two LAN Connections – 1, for the router (Internet) and the other for the Switch (Intranet).
You can go to your wireless router’s log in page to configure settings such as wireless passwords, an internet security and firewall settings. If your proxy server is installed, it should run and connect with the settings assigned on installation.
If your user accounts have been set up, they should be able to connect to the network without problems at this point.
I hope this helps.

What are you trying to configure on the Cisco switch? Whta kind of wireless router are you configuring?

Is the Cisco switch in question a Cisco IOS switch? Are you trying to configure port-security, Spanning Tree protocol, etc.? Let me know what you need help with and I'll help you as best as I can.

For Thin Client and Server Configuration see http://philmoreictlimited.ml/thin-client-and-computer-server-configuration/

Brief: We will configure your server for you. At a reasonable amount.

We can configure the server both on site and offsite.

For on site configuration, let us know the total number of terminals that will be connected to the server. On site Thin Client and Server Configuration is more expensive unlike off site configuration.

You will finance the transportation bill and cost of configuring the terminals and server.

For off site configuration, let us know the total number of terminals that will be connected to the server.

You will only need to download and install team viewer, then send the user ID and password to us via sms to 08086697100.