How do you like to do to make super accurate and rapid dot alignment on various targeting surfaces? It is not a hard work until users are getting the chance to make use of Berlinlasers red dot laser alignment. It is a direct diode emission dot measuring tool, within its wide range output power of 5mW to 100mW, it is not only workable for various work distances, but also able to be used with improving laser beam stability under formal dot aligning operations.
This red dot laser alignment is looking the same as a red laser pointer. It is giving up the use of simple alkaline battery, but using external DC input power supply. Owing to its good design of APC driving circuit board and metal heat sink cooling inside its metal housing tube, this red laser module is always getting quite nice thermal conductivity, and then making sure of the most stable dot alignment in long term use. Users should just make proper adjustment of laser beam focus and proper dot targeting direction adjust, a correct output power made red laser alignment gets wonderful measurement for laser marking, laser engraving, military targeting and others etc.