lyort:


if the gear works properly before the disassembly, i don't think there should be a problem with the converter except if he wants to replace it due to dirty transmission oil already living inside the converter which can contaminate the new oil. but if he has to reuse it he should ensure the sleeve of the support shaft that goes into the oil pump/gearbox is smooth or shiny silver and not brown (like its burnt due to overheating)

kola42:
Thank you for the information, it gear worked perfectly before i ntoticed oil leakage underneath

Ugo1986:
Honda accord or babyboy
Altermatic,Pls my honday baby boy is having this issure of, break and quench especially when u remove ur leg from pedal,this happens hence, u have load the gear ,the engine gradually goes off, if only u did nt hold the pedal,bt if u hold the d pedal the car il be moving, sometime the accellaration niddle will goes down to zero, den engine stop
These following messures has been taken,changing of plugs,fuel pump,changing /granding of no 2 & 3 valve from the top, changing of the injector mouth completly, replacement of the 4nozzles,all these culd nt stop the problems,these whole thing started from the very first day I remove the catalyst, can that be d cause?

Ugo1986:
Honda accord or babyboy
Altermatic,Pls my honday baby boy is having this issure of, break and quench especially when u remove ur leg from pedal,this happens hence, u have load the gear ,the engine gradually goes off, if only u did nt hold the pedal,bt if u hold the d pedal the car il be moving, sometime the accellaration niddle will goes down to zero, den engine stop
These following messures has been taken,changing of plugs,fuel pump,changing /granding of 2 &3 valve from the top, all these culd nt stop the problems,these whole thing started from the very first day I remove the catalyst, can that be d cause?

Hustlersdiary:
Good morning, can anyone help with the price of gear box for 2008 rav4 V6.

Hustlersdiary:
Good morning, can anyone help with the price of gear box for 2008 rav4 V6.

kingreign:


Location?
If I Abuja DM, I can recommend a transmission rebuilder.
If not in Abuja, scan & post codes.

Ugo1986:
Honda accord or babyboy
Altermatic,Pls my honday baby boy is having this issure of, break and quench especially when u remove ur leg from pedal,this happens hence, u have load the gear ,the engine gradually goes off, if only u did nt hold the pedal,bt if u hold the d pedal the car il be moving, sometime the accellaration niddle will goes down to zero, den engine stop
These following messures has been taken,changing of plugs,fuel pump,changing /granding of 2 &3 valve from the top, all these culd nt stop the problems,these whole thing started from the very first day I remove the catalyst, can that be d cause?

labisibrass:
Hello bosses. Please my Toyota Camry 08 v6 idles very high at around 2000. It goes back to 1000 whenever i get engage gear. Took it to a mechanic in Auchi and he said my throttle body is faulty, don't know if I get the name right (the thing be like a cylinder like this with a butterfly -like metal inside it) He said I need to change it which I did immediately as i would be travelling to Kaduna the next day. Took the vehicle to Kaduna the next day and I noticed the problem is still there. Last week, I took the vehicle to a new mechanic in panteka, Kaduna,he scanned the car and still complained about the throttle body. This time around,it will stay at 1000 at idle but will suddenly move up to like 2000 after a minute or so. He said I'll have to change it again. I was so concerned when he started to rub one thing like paint inside the throttle Body say it will not allow it to raised suddenly again. I'm not so comfortable with that approach Please I need your advice

2shure:
Sell it as accident free,itd already a scrap car

labisibrass:

Okay

kingreign:

Ignore that troll.
Scan the car and post codes. I'm looking at a vacuum leak, a throttle body malfunction or an ECM issue.

labisibrass:

Okay

kingreign:


Replace fuel pump ASSY.
Your fuel pressure regulator valve is either bad or the fuel casing rubber seal holding the fuel pump is absent

Abbeyismo:

Pressure relase valve inside the fuel pump might be bad.
The scan code did you work on the engine if no,the code wont stop it from starting ones.

billyfranc:
My Peugeot 406 is consuming lots of Fuel. I spend about 16k or 18k every three days on fuel for a distance that is not up to 1km - just city drive work and school runs only. I used to use 10 - 12L for one week, but now it's about 20L every three to four days. What could be the issue? The last time I scanned it (three weeks ago), I was told and shown that there were no permanent error codes and the temporary ones wiped immediately they were cleared. But, this high fuel consumption continued. My catalyst is also intact.
Please, help a brother!

jceesquare:

Why did you clear the temporary codes without noting them down?

Ugo1986:
My mechanic concluded that No: 2&3 valve are nt firing,afte replacing those plugs & nozzles,
Reason! Because the motor is steaming as if some plugs are malfunctioning,REMENBER,IT CAN ONLY STEAM,WHEN UR LEGS HOLD THE PEDAL, IF U REMOVE UR LEGS GRADUALLY THE ENGINE IL BE DROPPING TIL IT OFF.
NOW AFTER THE TOP & VALVE MAINTENANCE, THE FIRING IS GOOD, BT IT DOES NT STEAM, IT STEAM JUST A LITTLE & FINALLY ENGINE IL OFF

iomoge2:
Please what’s the range to bake Honda Crv 2008 now?

Abbeyismo:

Depend on the amount of dent on the car ma,
Theres hoven baked and theres normal painting.
Hoven baked #180k upward normal painting 100k upward.

kingreign:
This is a thread created for people to tell us their vehicle faults and we on our part can give solutions to their car faults. Where applicable, we may make references using pictures, videos and others to provide answers and solutions.

Please, state the name, model and year of your car, type of transmission and engine, and the location of the car to enable quicker response.my honda accord 2005 running lights not working, where is the drl relay located? Thanks.


Happy motoring!!