honmusa:
You will need to be more detail about what you want to achieve .That your engine is 5S-Fe Camry and it doesn't have a MAF .

mayor2013:
What is wrong with yours? Thats an intake air temperature sensor. Cleaning with fuel? Then you must be ready to get another one. There is a cleaning solution. A bit pricy though

ogawisdom:


More details provided read n advice further, where can I locate MAF sensor on this car

ogawisdom:


Nope my engine is see below, Toyota Carina E 1.6l auto 4afe factory fitted engine

D issue: I ve been running on CEL for 2year nw , changed oxygen sensor but CEL persists (I am nt worried much BC engine runs as if it is jst out of factory, no smoking but consumes fuel 20l/100km on city > I wanna try changing MAF sensor. My scan port seems faulty as it is nt detected by d scan guys I took it to, I noticed sth yesterday I am having slight hesitation/jerk if I step hard on my gas pedal. All my research points to MAF sensor cleaning hence this thread


Scan port pic attached too

honmusa:

Just like it bigger brother 5S-Fe ,Carina 4sfe doesn't have MAF ,the function of airflow measurement is done by MAP .
Hesitation or jerking must not always be air flow rate related (Maf/Map) ,it can also be ignition or fuel related but definitely it an indication of running lean .
Come for a diagnosis if you are in Lagos .
call autologic @ 08061166316

ogawisdom:


I am nt in anyway close to Lagos as I am located in abia, finding an enlightened mechanic here is like finding a fowl with teeth na kazeen full here though kazeen pass kazeen sha

U guys r right as I just learnt d car has air temp sensor and air pressure sensor doing d work of MAF. Where can I locate the air pressure sensor. Since CEL is on dnt u think it must b sensor related

honmusa:

For that model of car ,noticeable lean issue will be more fuel related than air .Go and perform a fuel pressure test (not fuel pump change o) diagnosis ,I will recommend a good professional that can do this for you in abia
call Donald @ 0806 388 5614 .

ogawisdom:


U r partially correct by saying it is fuel related. I took d car to my mechanic I will call him skilled kazeen. He jst drove d car around n came back n told me hear him "

oga nothing do ur car, u jst bought very bad fuel. Just go buy extreme fuel treatment n add in ur tank n u shld b fine. I told him I bought d fuel from reputable total filling station, he said it doesn't matter BC sometime they buy bad fuel too.

What do you think, I bought fuel full tank on Thursday last week n noticed hesitation/jerk yesterday. Do u think my mechanic could b right

Inception:
sorry for digressing but,

Oga Gazzuzz,

As regards fitting a manual (clutch type ) AC compressor in a 2008 Camry (2AZ-FE engine), would you recommend one taken from the 2003 Toyota Camry (big for nothing) that shares a similar (2AZ-FE) engine? or would you recommend the one from Toyota hilux(2.7 liter engine)?

Thanks for your anticipated response.

GAZZUZZ:
also check distributor setting. Ask your mechanic, if yours has 2bolts bolting it in, if it does, timing might have been tampered with and currently retarded, that would cause sluggishness and car would burn more fuel. You would need a timing light to properly set the distributor, but your mechanic could adjust by ear while revving to get a better setting.

ogawisdom:


Ok thanks everyone symptoms have disappeared ie slight hesitation n jerk on heavy acceleration my mechanic was right I bought bad fuel. I ve refilled n things seem to b normal again.

Pls which sensor is my hand pointing in d pic below and d socket circled in red n blue r they connected to sensors , is it MAP jst curious