Gazzuzz, mayor123, nurey, Obiekediamondfuto, timifakay, honmusa, autologic, ogakazeem, luvinhubby, autojoshng, autoelectng, egunmojaji, kingreign and other car guruz... I kindly call unto thee... My friend left his Accra tl 2005 model with me, I scanned it and two codes came..p0155 and p0135. After driving it.. I scanned and another code came up.. P2279 I checked the engine and discovered one hose has broken and mended with a tape..
Please kindly advice what do to.. Cos.. I would like to fix and clear those code..
Thanks guys.. Location is ph.. Thanks guys.. Pics attached..

No response??

DTC FAULT P0155 AIR FUEL RATIO A/F SENSOR BANK 2 (B2) SENSOR 1 . Inspect lambda sensor on bank2. Bank 2 is the front of your engine. Sensor 1 should be first sensor located in front of the engine(upstream).

Possible cause

1) heater element could be bad.
2) circuit problem

Solution: check resistance value using a multimeter. If you have a a scan tool you can check the sensor reading via actual values

P0135 Acura O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Sensor is located at the firewall (rear of the engine)

Carry same approach listed above to have it fixed

Lastly p2279: intake air Leak: have all vacuum hose inspected and fix accordingly. I would advise you have this code fixed first because the amount of intake air going to the engine has been altered so therefore lambda sensors would pick a false reading as against the norm air fuel ratio(14.7: 1). Have that intake air hose changed

N.B: Air fuel sensor might just check out fine but might come out as a fault code if you have this intake air leak

I hope this helps you

mayor2013:
DTC FAULT P0155 AIR FUEL RATIO A/F SENSOR BANK 2 (B2) SENSOR 1 . Inspect lambda sensor on bank2. Bank 2 is the front of your engine. Sensor 1 should be first sensor located in front of the engine(upstream).

Possible cause

1) heater element could be bad.
2) circuit problem

Solution: check resistance value using a multimeter. If you have a a scan tool you can check the sensor reading via actual values

P0135 Acura O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Sensor is located at the firewall (rear of the engine)

Carry same approach listed above to have it fixed

Lastly p2279: intake air Leak: have all vacuum hose inspected and fix accordingly. I would advise you have this code fixed first because the amount of intake air going to the engine has been altered so therefore lambda sensors would pick a false reading as against the norm air fuel ratio(14.7: 1). Have that inta
ke air hose changed

N.B: Air fuel sensor might just check out fine but might come out as a fault code if you have this intake air leak

I hope this helps you

nice and precise.
start with the leaks. ... that's a very serious leak!

captainking:
Gazzuzz, mayor123, nurey, Obiekediamondfuto, timifakay, honmusa, autologic, ogakazeem, luvinhubby, autojoshng, autoelectng, egunmojaji, kingreign and other car guruz... I kindly call unto thee... My friend left his Accra tl 2005 model with me, I scanned it and two codes came..p0155 and p0135. After driving it.. I scanned and another code came up.. P2279 I checked the engine and discovered one hose has broken and mended with a tape..
Please kindly advice what do to.. Cos.. I would like to fix and clear those code..
Thanks guys.. Location is ph.. Thanks guys.. Pics attached..

The car has really been abused..
If I was in your shoes, I will go this way

- Replace the rubber mended with tape( air Intake tube )
- check around engine bay for any sensor not connected.. If any, connect it.
- check for any other torn rubber hose in the engine bay
- Clear the codes
- Drive around and see what codes come up
- Then attend to any code the ECU throws

mayor2013:
DTC FAULT P0155 AIR FUEL RATIO A/F SENSOR BANK 2 (B2) SENSOR 1 . Inspect lambda sensor on bank2. Bank 2 is the front of your engine. Sensor 1 should be first sensor located in front of the engine(upstream).

Possible cause

1) heater element could be bad.
2) circuit problem

Solution: check resistance value using a multimeter. If you have a a scan tool you can check the sensor reading via actual values

P0135 Acura O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Sensor is located at the firewall (rear of the engine)

Carry same approach listed above to have it fixed

Lastly p2279: intake air Leak: have all vacuum hose inspected and fix accordingly. I would advise you have this code fixed first because the amount of intake air going to the engine has been altered so therefore lambda sensors would pick a false reading as against the norm air fuel ratio(14.7: 1). Have that intake air hose changed

N.B: Air fuel sensor might just check out fine but might come out as a fault code if you have this intake air leak

I hope this helps you

Thanks boss.. Will do that asap...

thebigkendo:


The car has really been abused..
If I was in your shoes, I will go this way

- Replace the rubber mended with tape( air Intake tube )
- check around engine bay for any sensor not connected.. If any, connect it.
- check for any other torn rubber hose in the engine bay
- Clear the codes
- Drive around and see what codes come up
- Then attend to any code the ECU throws

allrighr boss.. Will do that.. Thanks.. Though the car drives fine.. Just worried cos of the code.. Will attend to them asap

thebigkendo:


The car has really been abused..
If I was in your shoes, I will go this way

- Replace the rubber mended with tape( air Intake tube )
- check around engine bay for any sensor not connected.. If any, connect it.
- check for any other torn rubber hose in the engine bay
- Clear the codes
- Drive around and see what codes come up
- Then attend to any code the ECU throws

Seconded

mayor2013:
DTC FAULT P0155 AIR FUEL RATIO A/F SENSOR BANK 2 (B2) SENSOR 1 . Inspect lambda sensor on bank2. Bank 2 is the front of your engine. Sensor 1 should be first sensor located in front of the engine(upstream).

Possible cause

1) heater element could be bad.
2) circuit problem

Solution: check resistance value using a multimeter. If you have a a scan tool you can check the sensor reading via actual values

P0135 Acura O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

Sensor is located at the firewall (rear of the engine)

Carry same approach listed above to have it fixed

Lastly p2279: intake air Leak: have all vacuum hose inspected and fix accordingly. I would advise you have this code fixed first because the amount of intake air going to the engine has been altered so therefore lambda sensors would pick a false reading as against the norm air fuel ratio(14.7: 1). Have that intake air hose changed

N.B: Air fuel sensor might just check out fine but might come out as a fault code if you have this intake air leak

I hope this helps you

Lovely breakdown