xegzil:
Good day Engr,

My car (Corolla 08) has been misfiring and jerking , it was scanned and this code (P0302),
What we have done so far, We change all the plug, we change all the coil, and the nozzles were serviced,
The fuel pump was also changed, And the car still jerks and misfires ,

Pls advice,

Thanks

Check ECU, wiring and check compression on each cylinder if you’ve changed all these.

kingreign:


Fix misfire if cylinder 1 P0301. Check plug, coil, injector

Then replace the VVT solenoid which causes the rest of the codes

Good day Boss. The mechanic said I will need to change my camshaft. Pls what do you think. Am worried for the engine.

Jpeter1990:

Good day Boss. The mechanic said I will need to change my camshaft. Pls what do you think. Am worried for the engine.

I don’t know, I’m not present to check what’s happening to the engine so I can’t say much here.

kingreign:

I don’t know what to advise because I haven’t seen or assessed the block to know what’s happening sir.

Hello Sir, I changed my Nissan Pathfinder engine last month 3.5L engine. the engine work fine because I travel with it the following day. But when I got to my destination on the 3rd day morning, my gear was not reversing until like 4 to 5 attempt and nothing is wrong with the drive (this happen mostly in the morning or when I park for long), it still select very well because I travel a lot. Have been driving it like dat since. I don't know what could be the cause but it started 3rd day after I mount new engine. Which should be the first time I used the reverse.

Ur advice pls sir

Jollos:


Hello Sir, I changed my Nissan Pathfinder engine last month 3.5L engine. the engine work fine because I travel with it the following day. But when I got to my destination on the 3rd day morning, my gear was not reversing until like 4 to 5 attempt and nothing is wrong with the drive (this happen mostly in the morning or when I park for long), it still select very well because I travel a lot. Have been driving it like dat since. I don't know what could be the cause but it started 3rd day after I mount new engine. Which should be the first time I used the reverse.

Ur advice pls sir

What year pathfinder?
You may have to adjust/realign your PRND switch and/or cable

kingreign:

What year pathfinder?
You may have to adjust/realign your PRND switch and/or cable

2004

Immediately when I noticed it, I called my mech attention to it and he said maybe because some of the oil spilled when he was working on the engine. That he will have to top the gear oil and service the filter. He did dat and it actually it stopped for 2 weeks and resurface again yesterday.

I also noticed that button I press to release the gear is soft on like before or maybe I felt that way. Pls could dat also affect the gear not to engage reverse.

The mech said I should bring it tomorrow, that he will service some switch.

Pls tell me what and what I can tell him to check too.

I love my gear and my new engine it move like sport car, pls any help so that they don't spoil the gear for me.

kingreign:


Check ECU, wiring and check compression on each cylinder if you’ve changed all these.

The engine is still a virgin thou. But my mechanic said it may be the valve

xegzil:


The engine is still a virgin thou. But my mechanic said it may be the valve

Do what I asked pls and revert back.

[i][/i]My Lexus es 350 passenger rear window stopped rolling up, what could be the possible cause/fault?

Please proffer solution if possible
Thanks for your anticipation

Pedyson:
[i][/i]My Lexus es 350 passenger rear window stopped rolling up, what could be the possible cause/fault?

Please proffer solution if possible
Thanks for your anticipation

Have you carried out the relearn procedure?
If No, pls do the following. Turn on your ignition or start the car,
Press the passenger side window on that door, down fully, when it roll down completely, keep it pressed for 1-2 seconds, then pull up fully without taking your hands off the button, hold for 1-2 seconds. Then go to your driver side door and rest if the window operate as should. If it doesn’t operate as should. Pls check the following:

The window remote controller on the driver side, or the window regulator motor.

What could be my car problem?
I recently replaced my car brainbox but the key icon on the dashboard doesn't go off and car doesn't start but according to the guy who programmed the BRAINBOX, it's perfectly programmed but he's confused why the key icon on the dashboard keeps flashing.


We scanned it and got code p0606.
Car is Honda civic 2009

Please my Nissan primera car has overheating issue I have change timing chain change top gasket and its still overheating I went ahead and bought new radiator and its still overheating and I don't know what to do please help

Brightg:
Please my Nissan primera car has overheating issue I have change timing chain change top gasket and its still overheating I went ahead and bought new radiator and its still overheating and I don't know what to do please help

iOS your water pump and radiator fan okay?
Hope your engine hasn’t had a crack on the water jackets?

What is the cause of "tank vomit"? It is always difficult refuelling at the filling station. The nozzle will keep tripping off and the attendant get pissed off most time pumping fuel into my car tank. What do I do please?
Golf 3

Ameboperoo:
What is the cause of "tank vomit"? It is always difficult refuelling at the filling station. The nozzle will keep tripping off and the attendant get pissed off most time pumping fuel into my car tank. What do I do please?
Golf 3

Your tank pressure vent system is faulty.

kingreign:

Your tank pressure vent system is faulty.

Thanks. What do I need to do, buy or is to take to a mechanic or i can do it myself?

kingreign:


If you’re in abuja, I’d advise you visit me let me observe what’s wrong with it as I can’t place my head as to what’s going on with the car.

Chief, kindly share address orncontact and I'll show up tomorrow

creolehunt:


Chief, kindly share address orncontact and I'll show up tomorrow

07034581213
Kubwa

Seen. Kingreign, you can kindly remove your phone now

creolehunt:
Seen. Kingreign, you can kindly remove your phone now

No problem, let the number be there. I’ve been posting it since 2010

Pls @Kingreign my corolla 06 shows scancode p0420, p2401, p2402 evaporative emission system leak detect pump control circuit high. Am also having issues with once kick start. I've change the cold start switch, serviced nozzle, changed fuel pump but still the same issues. The car takes up to 10seconds to start when I turn ignition.
Pls I need assistant

tony360:
Pls @Kingreign my corolla 06 shows scancode p0420, p2401, p2402 evaporative emission system leak detect pump control circuit high. Am also having issues with once kick start. I've change the cold start switch, serviced nozzle, changed fuel pump but still the same issues. The car takes up to 10seconds to start when I turn ignition.
Pls I need assistant

For P2401 and P2402, replace your EVAP charcoal cannister. It’s under the car by the Torsten beam.
As for P0420, your catalytic converter or exhaust manifold or O2 sensor needs to be checked.
For the delayed start, a lot of things may be causing it. You need to visit your mechanic or electrician to check and narrow down to the fault and then fix it.

If you’re in Abuja, feel free to contact me if it’s ok by you.

My Camry 03 smokes heavily and the engine compression is very low, I had to park the car since last week at home. My mechanic said I should bring 150k to open the engine and check the crankshaft, rings and top cylinder, which im very doubtful.
Today I scanned the car and got error codes P0303 P0304 and P0300.

Pls kindly advice or recommend a good mechanic around Ago palace Okota. Thanks

masam:
My Camry 03 smokes heavily and the engine compression is very low, I had to park the car since last week at home. My mechanic said I should bring 150k to open the engine and check the crankshaft, rings and top cylinder, which im very doubtful.
Today I scanned the car and got error codes P0303 P0304 and P0300.

Pls kindly advice or recommend a good mechanic around Ago palace Okota. Thanks

If your mechanic can get genuine engine rebuild parts and is skilled in rebuilding engines, then you may go ahead, if not, pls buy another tokunbo engine.
As for location, I don’t know anyone in Ago palace Okota.

masam:
My Camry 03 smokes heavily and the engine compression is very low, I had to park the car since last week at home. My mechanic said I should bring 150k to open the engine and check the crankshaft, rings and top cylinder, which im very doubtful.
Today I scanned the car and got error codes P0303 P0304 and P0300.

Pls kindly advice or recommend a good mechanic around Ago palace Okota. Thanks

try trygo

Please advice me,

Just got this Nigerian used corolla. Mayor issue there is that whenever I put it in reverse gear and want to reverse, ignition will switch off. Please, what can be done to rectify it. Don't wanna become customer to mechanics

hspda:
Please advice me,

Just got this Nigerian used corolla. Mayor issue there is that whenever I put it in reverse gear and want to reverse, ignition will switch off. Please, what can be done to rectify it. Don't wanna become customer to mechanics

Year of manufacture, auto or manual transmission.

kingreign:


Year of manufacture, auto or manual transmission.

2003, Auto

hspda:


2003, Auto

Have you scanned the car to know what exactly is the cause of the malfunction?

kingreign:


Have you scanned the car to know what exactly is the cause of the malfunction?

.
No, I have not, maybe I will start from there. Thank you for you imput

Hello sir, I serviced my honda civic 2007 last week, the next day after servicingI noticed the car won't start once. Like I have to try like 2-3 times before it start which was never the case before servicing.

Secondly while driving sometimes VSA triangle and check engin light will pops up and the car jerks a little bit. Thoughit does not happen frequently, but I have not experience this before servicing the car. Once the VSA light pops up, I usually park my car and turn the engine off and on and the light will be cleared. Also I remove the battery terminals to clear the check engine light. And the car will become normal again.

After getting repeated issues I took the car back to the mechanic that serviced it, they scan the car and no problem was found. The mechanic said it probably might be bad fuel

Though I don't experience that starting 2-3 times before the car start again. But the VSA and check engine light still triggers once a while.

Pls what could possibly be the fault becauseI serviced the car from the same mechanic on January and I didn't experience any of this. Last week was my second servicing of the car this year and I am experiencing this problems